SAFFIRE MIXCONTROL ONY WORKS IN DAW PRO

More information about these can be found in Part I of this tutorial.Ĭlicking on the Routing Preset… button to the left of your monitor outputs in the routing pane gives access to the following five preset routing configurations that can be used as an alternative to configuring the routing manually: Mixes are the audio streams created by a combination of Inputs and DAWs.DAW contains all the audio streams coming back from your computer, whether from your recording software, from a media player, or from System Sounds.

This will route audio straight from the selected audio input, to the selected audio output, without incurring the latency of a round trip down the FireWire bus and back. Inputs are the audio inputs on your interface, both analogue and digital.As shown below, you will be able to choose between 3 different types of audio streams: Inputs, DAW, and Mixes. To assign an output, click on the button next to that output. This panel shows all of the available outputs on your interface (the screenshot above shows Saffire MixControl with a Liquid Saffire 56 connected), and each output has a button next to it that can be used to assign a specific audio stream to that output.

SAFFIRE MIXCONTROL ONY WORKS IN DAW PRO

Please Note: If you are using a Saffire PRO 24 DSP or a Liquid Saffire 56 and can only see the first 2 outputs, click on the button to the left of the one marked Routing Preset…, and select Router. This panel can be found in the bottom left-hand corner of Saffire MixControl. This is done predominantly using the routing panel, shown below. When you have created your mixes (see Part I of this tutorial), you then need to route them to the outputs of your device.

Applies to: Saffire Range and 1st Generation Scarlett 6i6, 8i6, 18i6, 18i8 and 18i20

Saffire mixcontrol ony works in daw